Operation; Commissioning; General - HADEF 22/90 Installation, Operating And Maintenance Instruction

Arrow keys = drive left / right
System start (optional)
Push button functions (E)
Relieved push button = stand still
push button half pushed = slow speed
push button pushed completely = fast speed
Red Emergency-Stop button
button pushed = stand still
turn the button clockwise = free functions
NOTICE!
Lockable Emergency-Stop buttons must first be opened with the key before unlocking!
8

Operation

The following, important points must be observed when operating the equipment:
 Read the safety instructions.
 Never load the devices beyond their working load limit.
 When changing the motor turning direction, allow the motor to come to a standstill first.
 The prescribed maintenance intervals must be adhered to.
 Observe the duty cycle, i.e. intermittent operation S3-40% ED (as per VDE 0530) means that in a period
of 10 minutes the motor can operate – no matter the height of the load – for 4 minutes. It is therefore
irrelevant whether the 4 minutes are continuous (i.e., in case of very high lifting heights) or are made in
intervals.
DANGER!
In particular, use is not permitted:
 in potentially explosive atmospheres, unless the equipment has been modified for this purpose and
this is shown on special type plates it carries for this purpose.

in reactor containments

for transporting persons

for holding lifted loads

for scenic use

when persons are under suspended loads
9

Commissioning

9.1

General

The operator of the unit is responsible for the entire system.
According to the Ordinance on Industrial Safety and Health, a hazard analysis must be carried out by the
operator.
Observe the respective national standards, regulations and directives of the responsible bodies at the place
of operation.
10
Illustration 4
Illustration 5
Illustration 6
Illustration 7
5.52.653.00.01.06