Inspection; Periodic Checks; Service; Electric Motor - HADEF 22/90 Installation, Operating And Maintenance Instruction

13

Inspection

13.1

Periodic checks

Independently from the regulations of the individual countries, lifting devices must be checked at least yearly
by a qualified person or licensed qualified person regarding its functional safety.
check screw connections
check the bearings
check the trolley wheels
check lubrication of the driving pinion
buffers - check correct position and wear
electric motor* - check the brake lining
electric motor* - check the brake
pneumatic motor*
Have the equipment checked by an expert
(periodic inspection)
*as far as applicable
14

Service

14.1

Electric motor

For the motor it is sufficient to keep the cooling airways clean and monitor the roller bearing and its
lubrication status.
A high temperature fat must be used if the roller bearing is replaced.
CAUTION!
Brake linings and surfaces must always be clean and fat-free. Even very small amounts of dirt can reduce
the braking moment considerably.
15

Trouble

Please pay attention to the following in case of problems:
 Troubles with the equipment must only be repaired by qualified personnel.
 Secure the unit against unintended operation start.
 Put up a warning note indicating that the unit is not to be used.
 Secure the working area of moving parts of the unit.
 Please read the chapter "Safety instructions".
Notes on the repair of faults are found in the following table.
For the repair of failures please contact our service department.
CAUTION!
Trouble caused by wear or damage to parts such as wire ropes, chains, chain wheels, axes, bearings,
brake parts, etc., must be remedied by replacing the parts with original spare parts.
5.52.653.00.01.06
at daily 1st maintenance
commissioning checks
X
X
X
X X
X
Inspection Inspection
after Maintenance Maintenance
3 months every
3 months 12 months
X X
every
X
X
X
X
X
X
X
13