Ethercat Factory Setting - Leuze electronic DDLS 538 S2 Series Original Operating Instructions

EtherCAT
Slave-side installation
For devices installed on the slave side, the MAS EtherCAT configuration must be deactivated. The MAS
LED of the device is off.
E therC A T
1
1 Master
2 Bus terminals
3 DDLS 538 ... S2 ... master side
4 DDLS 538 ... S2 ... slave side
5 Operating mode/MAS configuration = off
Fig. 7.2: MAS EtherCAT configuration deactivated
7.3

EtherCAT factory setting

Factory setting of the MAS EtherCAT configuration
The DDLS 538 ... S2 ... are delivered ex works with the following MAS EtherCAT configuration:
• Device with "Frequency F4": MAS EtherCAT configuration activated
• Device with "Frequency F3": MAS EtherCAT configuration deactivated
Leuze electronic GmbH + Co. KG
2
3
D D LS 538
„M A S " = on
DDLS 538 ... S2 ...
4
D D LS 538
I/O 's
„M A S " = off
5
52