Mounting Without Alignment Laser - Leuze electronic DDLS 538 S2 Series Original Operating Instructions

Optical data transmission for ethercat - version f3/f4

Hide thumbs

Table Of Contents

Table of Contents

Mounting

NOTICE

You will achieve greater flexibility during basic installation and fine adjustment if you mount the

devices on C profile rails.

Ä Detach the contour of the optical window from the drilling template along the perforation.

Ä Affix the removed drilling template to the optical window of the mobile device using the supplied self-ad-

hesive labels.

Ä Switch on the alignment laser of the stationary device. Activate the LAS (Alignment laser) operating

mode to switch on the alignment laser (see chapter 6.1 "Setting the operating mode").

Ä Move the mobile device on the lifting axis in manual operation to maximum distance.

Ä Align the stationary device using the alignment screws (see chapter 3.1.1 "Device construction",

point 11 and point 12) and, if necessary, using the C-profile rails.

ð The target spot of the alignment laser must be in the center of the drilling template on the mobile

device.

Ä Move the mobile device on the lifting axis in manual operation to minimum distance.

ð The target spot of the alignment laser must not extend beyond the outer ring of the drilling template

on the mobile device.

ð If necessary, realign the stationary device.

Ä Switch off the alignment laser of the stationary device. Activate the AUT (Automatic) operating mode to

switch off the alignment laser (see chapter 6.1 "Setting the operating mode").

Ä Affix the detached drilling template to the optical window of the stationary device using the supplied

self-adhesive labels.

Ä Switch on the alignment laser of the mobile device. Activate the LAS (Alignment laser) operating mode

to switch on the alignment laser (see chapter 6.1 "Setting the operating mode").

Ä Move the mobile device on the lifting axis in manual operation to maximum distance.

Ä Align the mobile device using the alignment screws (see chapter 3.1.1 "Device construction", point 11

and point 12) and, if necessary, using the C-profile rails.

ð The target spot of the alignment laser must be in the center of the drilling template on the stationary

device.

Ä Move the mobile device on the lifting axis in manual operation to minimum distance.

ð The target spot of the alignment laser must not extend beyond the outer ring of the drilling template

on the stationary device.

ð If necessary, realign the mobile device.

Ä Switch off the alignment laser of the mobile device. Activate the AUT (Automatic) operating mode to

switch off the alignment laser (see chapter 6.1 "Setting the operating mode").

Ä Remove the drilling template from the stationary device.

ð This concludes the mounting of the devices in the lifting axis.

Further procedure:

• Perform the fine adjustment for the lifting axis (see chapter 6.2 "Fine adjustment").

4.3