Vertical Mounting (Lifting Axis) With The Alignment Laser - Leuze electronic DDLS 538 S2 Series Original Operating Instructions

Mounting
Ä Point the alignment laser of the device that was mounted second at the drilling template on the device
that was mounted first. To do this, align the second device using the alignment screws.
ð The level as well as the parallelism of the laser spots to the guide rail does not need to be taken
into account here.
NOTICE
Do not change the mounting position of the device that was mounted first!
Ä When aligning the second device, note that the mounting position of the device that was
mounted first must not be changed.
Ä Switch off the alignment laser of the second device. Activate the AUT (Automatic) operating mode to
switch off the alignment laser (see chapter 6.1 "Setting the operating mode").
Ä Remove the drilling template from the device that was mounted first.
ð This concludes the mounting of the devices in the travel axis.
Further procedure:
• Perform the fine adjustment for the travel axis (see chapter 6.2 "Fine adjustment").
4.2.2

Vertical mounting (lifting axis) with the alignment laser

NOTICE
Vertical mounting only with the target spot of the alignment laser!
For the vertical mounting of the devices, only the target spot of the alignment laser is used (see
chapter 4.2.1 "Horizontal mounting (travel axis) with the alignment laser").
Ä The level and laser spots 1 ... 4 cannot be used.
Ä Mount the two devices opposite one another with a lateral offset of 30 mm. Mount the devices so that
the center of the transmitter of one device is opposite the center of the receiver of the other device.
Fig. 4.7: Lateral offset of the devices with vertical mounting
Leuze electronic GmbH + Co. KG
30 mm
DDLS 538 ... S2 ... 30