Vertical Mounting (Lifting Axis) Without Alignment Laser - Leuze electronic DDLS 538 S2 Series Original Operating Instructions

Mounting
4.3.2

Vertical mounting (lifting axis) without alignment laser

Ä Mount the two devices opposite one another with a lateral offset of 30 mm.
ð Place an alignment straightedge or level on the lateral support edge of one of the devices.
ð Move the devices towards one another horizontally so that there is an offset of 30 mm between
them (see figure). The transmitter of one device is positioned opposite the receiver of the other de-
vice.
Fig. 4.9: Lateral offset of the devices with vertical mounting
Ä Determine the horizontal mounting position of both devices.
ð Place an alignment straightedge or level on the planar support surfaces in the connection area of
both devices.
ð Move the devices until both are flush with one another. To do this, use the vertical level of a bubble
level.
ð Mounting of the device is concluded.
Further procedure:
• Connect the devices electrically (see chapter 5 "Electrical connection").
• Perform the fine adjustment for the lifting axis (see chapter 6.2 "Fine adjustment").
Leuze electronic GmbH + Co. KG
30 mm
DDLS 538 ... S2 ... 33