HADEF 238/10-EX Installation, Operating And Maintenance Instruction page 18

CAUTION!
The brake linings must be free from fracture. Avoid oil, grease, dirt and humidity on the brake linings as this
increases wear.
13.4 Lubricant - Selection
FUCHS SHELL
Renolit FEP 2 Alvania EP 2
Stabylan 5006 --
-- --
Lubricant for food industry – Selection (as option*)
13.5
SHELL
Gearing
FM Grease HD2
Load chain
--
Load hook;
Pulleys
FM Grease HD2
Gear rim;
Drive pinion
* must be mentioned by order
14 Trouble
Please pay attention to the following in case of problems:
 Troubles with the equipment must only be repaired by qualified personnel.
 Secure the unit against unintended operation start.
 Put up a warning note indicating that the unit is not to be used.
 Secure the working area of moving parts of the unit.
 Please read the chapter "Safety instructions".
Notes on the repair of faults are found in the following table.
For the repair of failures please contact our service department.
CAUTION!
Trouble caused by wear or damage to parts such as wire ropes, chains, chain wheels, axes, bearings,
brake parts, etc., must be remedied by replacing the parts with original spare parts.
15 Remedy
Trouble
It is difficult to turn the crank if unloaded
load is not lifted, resp. held
load pressure brake does not open.
16 Decommissioning
WARNING!
It is essential that the following points are observed in order to prevent damage to the equipment or critical
injury when the device is being decommissioned:
18
ESSO MOBIL
Unirex EP 2 Mobilux EP 2
-- --
-- --
Chain lubricant OKS 451
MOBIL
Mobilgrease FM 222
Optimol Viscoleb 1500
Lubricant FM 100
Mobilgrease FM 222
Cause
not lubricated
worm gear is dirty
wrong installation
rope is not winded correctly - rope turning direction for
lifting is not correct
brake is worn or defective
brake discs are humid or oiled
brake mechanism or brake disc is stuck, possibly due to
seldom use
TOTAL CASTROL
MULTIS EP2 --
-- Optimol Viscoleb 1500
-- --
KLÜBER
CASTROL
--
Klüberoil 4UH 1-1500 N
--
--
--
Remedy
lubricate the worm gear and the worm gear shaft,
clean and lubricate again
straighten supporting surfaces and install correctly, if
necessary
place the wire rope correctly
check brake parts and replace parts that are worn
clean brake discs or replace them by new ones
loosen the brake by slightly pushing the winch handle by
hand (in direction lowering)
replace the brake discs if necessary
KLÜBER
--
Klüberoil 4UH 1-1500
Wolfracoat 99113
5.52.208.01.01.02