Mount The Library In The Rack - Spectra Logic T-Series Spectra T50e Install Manual

Rack-mount Instructions
4. Repeat Steps 1 through 3 to install the right-side rail.

Mount the Library in the Rack

The library weighs approximately 34.4 lb. (15,6 kg).
Warning
Two people are needed to move or lift the library. Most of the
weight is toward the back of the library.
German: Der Library hat ein Gewicht von ungefähr 15,6 kg.
Zwei Personen sind notwendig, zu verschieben oder
Aufhebung der Library. Die schwersten Komponenten
befindern sich im hinteren Teil der Library.
Do not install the rubber feet if you are installing the library in a rack, as they are
Important
meant for a tabletop installation only!
1. Lift the library onto the shelf formed by the rails.
2. Slide the library completely into the rack so that the mounting brackets
3. Using a #3 Phillips screwdriver, install one M6 screw in each mounting
The rack installation is now complete.
8
Rack-mount Instructions
Note: Make sure you install the right-side rail at the same level as the
left-side rail so that the shelves on both are level from right to
left. Otherwise the library will not be level when installed in the
rack.
Use a level to verify that the rail is level from front to back and
the shelf formed by the rails is level from left to right.
are against the posts.
bracket to secure the library to the rack, as shown in
Figure 2 Secure the library to the rack (right side shown).
Figure 2.
Post
Mounting
bracket screw
90970019