Install The Rails In The Rack - Spectra Logic T-Series Spectra T50e Install Manual

Install the Rails in the Rack

1. Position the left-side rail assembly in the rack so that the front flange is
Position rail
1
behind front flange
Front of Rack
Figure 1 Install the rails in the rack.
2. Adjust the length of the rail assembly as necessary to fit the depth of the
3. Using a #3 Phillips screwdriver, install four M6 screws—two in the
December 2008
behind the front screw holes in the rack
Note: Make sure that the front and back of the rail are attached to the
rack at the same height on the front and back posts. Otherwise
the library will not be level when installed in the rack.
Using a level simplifies the leveling procedure.
Simplified
Front Rear
rack rail
Install rails with "flat" edge
in the front and the "angled"
edge in the rear of the rack.
rack ( ).
2
front and two in the rear—to secure the rail to the rack (
the screws securely.
Note: Two sets of M6 screws are provided. The type you use depends
on the type of rack you have. Use the screws with the larger
shoulder for racks with square holes.
To simplify the installation, have a second person support the
rail while you install the screws.
Leave the middle hole in each rail empty. You will use them
when attaching the library's mounting brackets to the rack.
(Figure
Back of Rack
2
Adjust to fit
depth of rack
3
Secure with
screws
Spectra T50e Library
Rack-mount Instructions
1, step ).
1
). Tighten
3
7