Table of Contents
Advertisement
14. Press the two tabs (not shown) on the Tablet
Holder (27) into the slots (J) in the console
assembly (G).
Attach the Tablet Holder (27) with four
M4 x 16mm Machine Screws (6). Tip: Start the
two upper Machine Screws first, and then
start the two lower Machine Screws. Do not
overtighten the Machine Screws.
IMPORTANT: The Tablet Holder (27) is
designed for use with most full-size tablets.
Do not place any other electronic device or
object in the Tablet Holder.
15. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex key in a secure
place; the hex key is used to adjust the walking belt (see pages 27 and 28). Note: Extra hardware may be
included.
14
Start First
6
15
27
6
G
J
Advertisement
Table of Contents
