How To Register A Destination - Develop ineo+ 360i Quick Manual

8.1

How to register a destination

8 Registering a destination
8.1 How to register a destination
Registering a fax address
1
Tap [Utility] - [Utility] - [Store Address] - [Address Book] - [New Registration].
2
In [Select Destination], select [Fax].
3
Enter destination information.
Setting
[No.]
[Name]
[Index]
[Destination]
[Confirm Fax Num-
ber]
[Line Setting]
[Communication
Setting]
4
Tap [OK].
ineo+ 360i/300i/250i
Description
Destination registration number. Select [Use opening number] to automati-
cally assign the smallest available number. When you want to specify a num-
ber, select [Direct Input] and then enter a number.
Enter the destination name (using up to 24 characters).
Select an index to search for a destination using the registered name.
For a frequently used destination, select the [Main] check box. The destina-
tions are displayed on the destination selection screen, enabling the user to
easily select a destination.
Enter the destination fax number (using up to 38 digits, including symbols #,
*, -, and characters T, P, and E).
• [T] or [*]: Enter the fax number when issuing a push signal in dial-up line
mode (while [Dialing Method] is set to [10pps] or [20pps]).
• [P]: Enter this when you want to insert a wait time between dials.
• [-]: Enter this to separate a dial number. It does not affect the dialing of
the number.
• [E-]: Enter the registered outside line number in PBX environment. Enter
this when [PBX Connection Setting] is set to ON.
Enter the fax number again.
This option is displayed when [Function ON/OFF Setting] - [Confirm Address
(Register)] is set to ON.
If multiple lines are used, select the line used to send a fax.
In general use, use [Line 1]. If [Normal] is selected, either line, whichever is
not busy, is used for transmission.
If necessary, specify how to send a fax to a destination you want to register.
You may change the settings you made here before sending a fax.
• [V34 Off]: V.34 is a communication mode used for super G3 fax commu-
nication. When the remote machine or this machine is connected to a
telephone line via PBX, however, you may not establish a communica-
tion in the super G3 mode depending on telephone line conditions. In
this case, it is recommended that you turn the V.34 mode off to send da-
ta.
• [ECM Off]: ECM is an error correction mode defined by ITU-T (Interna-
tional Telecommunication Union - Telecommunication Standardization
Sector). Fax machines equipped with the ECM feature communicate
with each other, confirming that the sent data is free of errors. This pre-
vents image blurring caused by telephone line noise.
The communication time can be reduced by setting ECM to OFF for
transmission. However, an image error or communication error may oc-
cur depending on the specified communication time value, so change
the value to suit conditions.
• [International Communication]: Used to send a fax to areas where com-
munication conditions are poor. Faxes are sent at a lower speed.
• [Check Destination]: The fax number specified for fax is checked against
the destination fax number (CSI) and the fax is sent only when they
match.
8
8-3