General Safety Notes; Safety Notes For Operation - Efco SIRIUS 700 Operators Instruction Book

Table of Contents

Advertisement

Safety devices
Safety devices are not allowed to be bypassed, manipulated
or removed. Failure to comply can endanger your own
health and that of other people.
The robot lawnmower is protected by a PIN code in order
to prevent it from being switched back on inadvertently or
without authorisation.
The robot lawnmower is supplied from the factory with the
PIN code 0000.
A PUK code must be entered if the PIN code is entered
incorrectly three times. Request this from your dealer.
The robot lawnmower is equipped with a safety sensor.
If the robot lawnmower is lifted up, its motor and cutting
blades are stopped within 2 seconds.
After contact with an obstacle, the robot lawnmower
moves back, stops and changes its direction of travel.
3.2

General safety notes

The owner is responsible for accidents involving other people
and their property.
Caution!
Danger of injury.
Do not deactivate safety and protective
devices.
The robot lawnmower is not allowed to be operated by
anyone who has not mastered safe handling of the robot
lawnmower and/or has not read and understood the
instructions for use.
During mowing, make sure that no-one places any part of
their body in the vicinity of the rotating cutting blades.
If the robot lawnmower is defective, e.g. on its cutting
blade(s), cable or base station, then do not take it into
operation.
Have the defects repaired profi ciently.
Warning!
Take maximum care to ensure that children
and animals are never allowed near the
machine.
Do not allow children to play with the device
3.3

Safety notes for operation

Warning!
Switching on inadvertently or unauthorised
use can lead to extremely serious injuries.
The robot lawnmower must be switched off
and secured with a PIN code.
Note!
Keep the PIN code and PUK code where they cannot
be accessed by unauthorised people.
The PIN code can be changed by the owner.
If the PIN code is entered incorrectly three times, it will
be necessary to enter a PUK code.
If the incorrect PUK code is entered you must wait 24
hours before making a repeat attempt.
Regularly check the robot lawnmower and the base station
for damage.
The replacement or repair of damaged components and
batteries should be entrusted to specialist workshops
approved by the manufacturer.
Note!
Never carry out operations or repairs on your own that
are other than routine maintenance. Call specialised
and authorised workshops only.
49

Advertisement

Table of Contents
loading

Table of Contents