Table of Contents
Advertisement
14.3
Checking/cleaning the base station
1
1 Disconnect the transformer mains plug.
2 Check the contac ts (1) on the base station for
contamination.
3 Clean the contacts (1) on the base station using a cloth if
necessary.
4 Push the contacts (1) towards the base station and release.
The contacts (1) must spring back into the initial position.
5 If the contacts (1) do not spring back into the initial system,
have them checked by an Authorised Service Centre, and
renewed if necessary.
14.4
Cleaning the chassis
Thoroughly clean grass catcher (1) and guide (2) using a
hand brush or a cloth.
72
15
Repair
Warning!
Injuries due to the cutting blades!
Switch off the robot lawnmower at the
[ON/OFF key] before starting maintenance
and repair work.
Always wear work ing gloves when
carr ying out maintenance and care
jobs on the blade system.
Disconnect the transformer of the base
station from the mains.
Important!
Damage due to an incorrect repair!
Never repair damaged cutting attachments
by welding, straightening or modifying the
shape. This may cause parts of the cutting
tool to come off and result in serious or
fatal injuries.
15.1
Renewing the cutting blade plate
1
2
1 Place the robot lawnmower with the cutting blades (3)
pointing upwards.
2 Hold cutting blade plate (2) fi rmly.
3 Unscrew and remove three screws (1).
4 Pull off cutting blade plate (2) with the cutting blades (3).
5 Put on cutting blade plate (2) with the cutting blades (3).
6 Brace cutting blade plate (2) fi rmly.
7 Screw in and tighten new screws (1).
1
2
3
Advertisement
Table of Contents
