Table of Contents
Advertisement
10
Setting menu
Set the time.
Set the date.
Set the language.
Changing the PIN code
Set the button tones.
Activate or deactivate the margin movving.
Set the display contrast.
Reset calibration.
Restore factory settings
10.1
Setting the time
Selecting the program
Before programming, it is necessary to perform the start
procedure (see page 64 ).
1. Use the [up arrow key] or the [down arrow key] to select
the [Settings] menu item.
2. Call up the [Time] menu.
3. Confi rm with the [multifunction key right].
Note!
When setting the time, it is necessary to select each
individual digit until it fl ashes.
Enter the time correctly, because further programming
depends on the time.
Confi rm individual digits and use the arrow keys to select
the next digit.
The time is displayed in 24-hour format.
1. Select the required time with the [arrow keys] and confi rm
with the [multifunction key right].
Exit setup mode by pressing the [Menu key] twice.
10.2
Setting the date
Selecting the program
Before programming, it is necessary to perform the start
procedure (see page 64).
1. Select the required program item with the [arrow keys] and
confi rm with the [multifunction key right].
2. Call up the [Date] menu.
Setting the date
Note!
Enter the date correctly, because further programming
depends on the date.
When entering the year (YYYY), it is only necessary to enter
the last two digits because the fi rst two 20XX are preset.
The date display is structured as follows:
DD for the day.
MM for the month.
YYYY for the year.
67
Advertisement
Table of Contents
