Table of Contents
Advertisement
6.7
Setting/changing the time
1. Use the corresponding [arrow keys] (1) or (2) to select
the corresponding digits and confi rm each one with the
[multifunction key] (3).
Following this, the LCD display shows the [Uncalibrated] status
box.
6.8
Calibration
Note!
For calibration, set up the robot lawnmower accordingly, see
page 58 .
Warning!
The drive starts when the [START key] is
pressed.
Do not reach into rotating parts.
1. The automatic calibration procedure starts when the
[START key] is pressed.
The [Drive starting] warning fl ashes on the LCD display.
60
Calibration procedure starts
The robot lawnmower first moves straight over the
boundary cable in order to gauge the signal strength,
and then into the base station.
Note!
The robot lawnmower must remain stopped when it moves
into the base station. If the robot lawnmower does not meet
the contacts when it moves into the base station, it will move
further along the boundary cable until it meets the contacts
or the procedure is cancelled.
The battery of the robot lawnmower is charged.
Advertisement
Table of Contents
