Table of Contents
Advertisement
5.8
Opening the cover on the rear of the
base station
Note!
The cover only has to be opened for the purpose of
checking the LED displays.
To check the connection, unscrew the fastening screws (3)
and remove the cover (2) from the base station (1).
5.9
1
2
3
The yellow LED (1):
lights up if the base station is connected to the transformer
and there is an electrical power supply to the transformer.
fl ashes when the robot lawnmower is charging.
The green LED (2):
lights up when the boundary cable is laid correctly and the
loop is OK.
The green LED fl ashes and then goes out if the loop of the
boundary cable is not OK.
Checking the connection
1
2
Important!
Damage to the cables.
The LEDs must light up when the cables are
connected. If this is not the case, pull out the
mains plug and check if all plug connections and
cables are correctly seated; also check them for
damage.
57
Advertisement
Table of Contents
