Advertisement
6.10
Connecting the LAN Switch Cable
1. Connect the FE1 port on the LAN switch to
the ETH1 port on the SmartLogger using the
network cable delivered with the LAN switch.
2. Connect the factory-installed power cable to
the LAN switch using the wiring terminal
delivered with the LAN switch.
Connect the SWITCH-12V+ cable to the V+
power port on the LAN switch, and the
SWITCH-12V– cable to the V– power port on
the LAN switch.
6.11
Connecting the Peripheral Network Cable
Connect peripheral network cables to ports FE2–FE5 on the LAN switch. All network cables are
connected in the same way. This section describes how to connect one network cable.
1. Prepare a network cable.
2. Verify that the network cable functions
properly using a network cable tester.
3. Connect the peripheral network cable to
the FE2 port on the LAN switch.
4. Bind the network cable.
(1) White-and-orange
(3) White-and-green
(5) White-and-blue
(7) White-and-brown
22
(2) Orange
(4) Blue
(6) Green
(8) Brown
Advertisement
