Section Three - Service - Southbend 1364 Owner's Manual

\
\
ADJUSTMENTS
STANDARD-TYPE OVEN: BY-PASS FLAME MINIMUM BURNER FLAME)
The pilot must be lit to make this adjustment.
1. Remove oven bottom so burner is visible.
2. Turn on oven valve.
3. Turn thermostat to 200°F so main burner ignites.
4. With oven cool, turn dial clockwise slowly until by-pass seat just snaps OFF.
5. Immediately reverse rotation and turn dial oounterolockwise until by-pass snaps open.
6. Remove dial.
7. With a screwdriver, turn 'by-pass flame adjustor" screw counterclockwise to increase the by-
pass flame or oh&wise to decrease the entire burner to a l/8" minimum - l/4" maximum
stable flame. (See Fig. 2, Section 3, Page 3.1
8. Replace dial.
NOTE: While making this adjustment, if the oven should become heated while the dial is set at
a low range (below 350 o F), the by-pass flame will shut off completely. If this oocurs, turn dial coun-
terclockwise slowly until by-pass gas snaps on- Then oheok by-pass adjustment as stated above.
THERMOSTATIC GRIDDLE: BY-PASS FLAME @fINMUM BURNERFLAME)
The pilot must be lit to make this adjustment.
1. Turn thermostat dial to 300°F. Burner should light. Observe burner through slots in grease
trough.
2. After temperature rises and remains constant turn dial back to "low." This closes main valve
and permits only by-pass gas to burner.
3. Remove dial.
4. With a screwdriver, turn "by-pass flame adjustor" screw ootmterck&wise to increase the by-
pass flame or clockwise to decrease it until flame over the entire burner is a l/8" minimum
-
I.&"
maximum stable flame. Replaoe dial. (See Fig. 3, Section 3, Page 4)
B%ER I
I Bm I
BY-PASS OR
SIMMEaPLAME
OVEN
3i4" to 1" By-pass l/3" to l/4"
Must heat capillary to keep
Up to, and spread on
Convection Type Oven
flame switch activated
fire plste approx. 3" N/A
on each side
Graduated Heat Top 1
Uniform Heat Top
I
314"
I
li2" to 314'
I
118" to l/4"
FWTOP
I
3f4"
I
l/2" to 5lV
I
l/0" to ll4"
Themmstatic Fry Top 1 314"
I
l/2" to 5l8"
I
US" to 114"
Grate Top l/2" to 513"
Impinge on pot
set on grate
AU pilot flames should be stable and not carbon producing.
AI1 burner flames should be stable blue without blowing or yellow tipping.
l/8" to lJ4"
SECTIONAL RANGES
SECTION THREE - SERVICE
PAGE 2
mdn&S.A.