Operation - Southbend 1364 Owner's Manual

B
OPERATION
FOR AN APPLIANCE EQUIPPED m CASTERS, THE INSTALLATION SHALL BE
MADE WITH A CONNECTOR THAT COMPLIES WITH THE STANDARD FOR
CONNECTORS FOR MOVABLE GAS APPLIANCES, ANSI 221.69-1987, CAN1 6.16-66
AND A QUICK-DISCONNECT DEVICE THAT COMPLIES WITH THE STANDARD FOR
QUICK-DISCONNECT DEVICES FOR USE WITH GAS FUEL, ANSI 221.41-1978, AND
ADDENDA, 221Ala-1981,221.41bl963 AND CAN1 6.9 M79. ADEQUATE MEANS MUST
BE PROVIDED TO LIMIT THE MOVEMENT OF THE APPLIANCE WITHOUT
DKPENDING ON THE CONNECTOR AND THE QUICK-DISCONNECT DEVICE OR I'IS
ASWCMEDPlPINGTO~~-CEMOVEMENT.
WARNING:
IF DISCONNECTION OF THIS RESTRdNT IS NECESSARY TO REMOVE THE
APPLIANCE FOR CLEANING, ETC., RECONNECT IT WHEN THE APPLIANCE IS
MOVED To ITS ORIGIIWLIXINSI'ALLED POSITION.
Before
turning main gas supply on, make sure all control valves are in the "OF
positicm.
All units are adjusted at the factory. On new installations start with the top burner of the unit&)
furthest from the gas input to the manifold This will purge the system of air. Turn gas supply "ON."
STANDARD-TYPE OVEN:
1. Open door, raise hold-down clips and remove oven bottom so burner is visible.
2. Turn oven burner to OFF.
3. Remove1 panel from spring compartment below oven door.
4. Depress BED button on safety valve and light pilot. New instaBations may require time to bleed
air &om system before pilot will become steady. The pilot flame should impinge on the bulb to
cause it to glow red. If flame is too long and soft, bulb may be in "hollow" part
of
flame and
till not glow.
5. Hold red button allowing pilot to burn approximately 45 seconds, until tip of bulb glows red,
and then release button.
lf pilot does not remain ignited, wait 5 minutes and repeat procedure.
NOTE: The lighting procedure is also printed on a plate attached to the
front
ofthe spring com-
partment cover.
6. Once pilot holds when button is released, set thermostat dial to maximum and turn ON the oven
valve at manifold.
7. Burner flames should be 314" to 1" long.
8. Reduce thermostat setting slowly until by-pass seat in thermostat just snaps OFF.
Bnmediately reverse rotation and turn-dial counterclockwise until by-pass snaps open.
The by-pass frame should be l/3" minimum and l/4" maximum on each port.
A small fluttering by-pass flame may flash back into the burner and ignite on the orifice when
the door is quickly opened and closed. This will create a carbon deposit inside the burners which
impedes proper primary air injection.
9. Check entire oven gas system for leaks.
10. Replace oven bottom and be sure hold-down clips sre lowered to keep bottom in place and pre
vent warping. Replace spring compartment panel.
For duily shutdown turn muin oven valve OFF. For complete oven shutdown turn main Owen valve OFF
and extinguish oven pilot.
SECTIONAL RANGES
SECnON TWO - USER'S GUIDE
Utha in U.S.A.
PAGE 2 4-92