HIKVISION DS-KD8003-IME1 Quick Start Manual page 57

Video Intercom Module Door Station·Quick Start Guide
9. Fill and level up the gap between the frame and wall with concrete. Remove the
locating plates after the concrete is dry.
10. Pass the main unit connecting lines across the thread hole to the top grid of the left
frame.
Thread the module-connecting line across the thread hole of the frame.
The lines should be placed as below:
11. Connect the cables and module-connecting line 1 to the corresponding interfaces of
the main unit, then place the main unit into the upper grid.
Connect the other end of the module-connecting line1 to the input interface of the
sub module. Connect all sub modules via module-connecting lines.
Organize the line with cable tie in the package. The suggested line connection picture
as below.
Figure 3-54 Placement of Lines
49