Table of Contents
Advertisement
42 Electrical installation
6.
For each cable, attach the conductive sleeve to the bare cable shield with a cable
tie. Attach the cable to the support bracket with a clamp.
7.
For each cable, connect the PE conductor to the PE busbar, and two phase
conductors to the phase terminals. Connect the third phase conductor to the PE
busbar. Tighten the screws to the torque given in the technical data. Use the bolts
and washers in the delivery. Refer to
connections (page
6
8.
If there are more than 3 cables, attach additional cable support brackets for them.
Installing shrouds
1.
Install the thermal switch cable. Refer to section
thermal switch
cable.
2.
Install the shrouding removed earlier.
3.
Close the cubicle door.
Use of fasteners in cable lug
43).
7
Connection procedure of the
Advertisement
Table of Contents
