Adding The Gear Oil - Husqvarna TC 85 19/16 2020 Owner's Manual

16.3

Adding the gear oil

Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
SERVICE WORK ON THE ENGINE 16
Guideline
Oil drain plug with
magnet
–
Remove filler plug
Gear oil
–
Mount and tighten filler plug
Danger
Danger of poisoning Exhaust gases are toxic and
inhaling them may result in unconsciousness and
401955-11
death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the gear oil level. (
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
Main work
–
Remove screw
V01305-10
–
Remove filler plug
–
Add gear oil up to the bottom edge of the hole of the gear oil
level plug.
Engine oil (15W/50) (
–
Mount and tighten screw
Guideline
Screw, gear oil level
monitoring
401955-11
–
Mount and tighten filler plug
M12 20 Nm (14.8 lbf ft)
2
with the O-ring, and fill up with gear oil.
0.50 l Engine oil (15W/50)
(0.53 qt.) (
2
with the O-ring.
p. 108)
1
with the seal ring.
2
with the O-ring.
p. 125)
1
with the seal ring.
M6 8 Nm (5.9 lbf ft)
2
with the O-ring.
p. 125)
109