Installing The Horizontal Bracket On The Ct28 - 1 Sound Contour CT28 Installation Manual

Figure 50. Removing the end plates from the wall-
mount yoke .
• Once the plate has been removed completely from one end of
the bracket, repeat the above process to remove the plate from
the opposite end.

Installing the Horizontal Bracket on the CT28

Once the two end-plates of the bracket have been separated from the
wall-mounted yoke, they can be easily attached to the CT28 enclosure.
Important: For permanent or semi-permanent installation,
the use of medium-strength thread-locking compound is
recommended on all user-installed screws.
| 4 - INSTALLING CT28 ON THE HORIZONTAL MOUNTING BRACKET
Figure 51. The rear panel of the CT28 with the
mounting points for the bracket indicated.
• Lay the enclosure on its front grille, taking whatever necessary
precautions to avoid damaging the finish of the cabinet or the
grille.
• Using a 4 mm hex wrench or hex driver, remove the two M6
× 25 mm screws from the top rear of the enclosure, inside the
recess. Keep these, as they will be used to install the bracket.