Table of Contents
Advertisement
Chapter 2. Accessories
CT28 Wall Bracket
Wall-mount bracket with tilt and pan adjustment
Figure 2. CT28 Wall Bracket
This bracket attaches to the rear of the Contour CT28 enclosure and
mounts to a wall. It allows for variable positioning on both the horizontal
and vertical axes. The vertical positioning can be tilted down to 25°. The
bracket is made from stainless steel 316, or galvanized zinc plated steel
with black or white powder coating.
The kit includes:
•
The fully assembled Wall Bracket
CT28 Horizontal Mounting Bracket
Wall- or ceiling-mount bracket with tilt adjustment
Figure 3. Horizontal Mounting Bracket
This bracket is for horizontal installation of a CT28 on a wall, allowing
for vertical aiming on a wall. It can also be used for ceiling mounting,
facilitating both vertical and horizontal positioning. The bracket is made
from stainless steel 316, or galvanized zinc plated steel with black or
white powder coating.
The bracket can be used together with the CT28 Angle Bar, allowing
CT28 to be positioned flush to the wall or ceiling, or extend the tilt up to
a maximum of 75° away from the wall or ceiling.
The kit includes:
•
The fully assembled Horizontal Bracket
CT28 Angle Bar
Angled extension for the Horizontal Mounting Bracket
Figure 4. The CT28 Angle Bar
The Angle Bar attaches to the Horizontal Bracket in order to extend the
tilt angle. It can either extend the tilt angle so the CT28 is flush to the
wall or the ceiling to which it is mounted, or it can allow a range of tilt
angle from 15° to 75° away from the wall or ceiling. The bar is made from
stainless steel 316, or galvanized zinc plated steel with black or white
powder coating.
The kit includes:
•
The angle bar
•
4 × M8×20 bolts
•
4 × M8 stainless steel lock nuts
Advertisement
Table of Contents
