Mounting And Pointing The Ct28 - 1 Sound Contour CT28 Installation Manual

Figure 114. Applying downward force to verify the
mount.
• Apply force or weight to the mounting yoke to verify physically
its ability to support the necessary load. There must be no
movement possible between the Angle Bar and the wall/ceiling,
nor between the yoke and the Angle Bar.

Mounting and pointing the CT28

Once the yoke of the Horizontal Mounting Bracket has been mounted
to the Angle Bracket and to the wall, and the end plates of the bracket
are installed on the CT28 enclosure, the installation can be completed
by re-coupling the components of the bracket, securing and pointing the
loudspeaker to achieve the required coverage.
Two People Required
The following task simultaneously requires moderate
two-handed lifting and the performance of fine motor
operations. To avoid possible injury or damage, this
procedure must be performed by two people
Figure 115. Lifting the CT28 onto the ceiling-
mounted yoke.
| 5 - INSTALLING CT28 ON THE HORIZONTAL MOUNTING BRACKET AND ANGLE BAR
CAUTION
Figure 116. Fitting the CT28 with plates onto the
yoke of the Horizontal Mounting Bracket (Top
View).
• Lift the CT28 (with the end plates of the bracket installed) in front
of and slightly above the yoke, aligning the end-plates on the
outside of the upward-facing hooks of the wall-mounted yoke.
Figure 117. Aligning the lug on the angle-
adjustment plate with the hook on the yoke.
• Lower the speaker enclosure so that the two lugs on the end-
plates engage the hooks on the wall-mounted yoke. DO NOT
release the CT28.