Table of Contents
Advertisement
Figure 122. Example alignment of an odd angle (-45°
ceiling mount shown) .
• When the holes in the bracket ears are correctly aligned with
the threaded inserts in the wall-mounted yoke, according to the
selected tilt angle, the second operator should insert the M6 bolt
(one of those removed during
page
22)) through the appropriate hole for the selected angle
and thread it into the bracket.
Figure 123. Tightening the tilt-locking bolt into the
Horizontal Mounting Bracket (-40° shown).
| 5 - INSTALLING CT28 ON THE HORIZONTAL MOUNTING BRACKET AND ANGLE BAR
disassembly of the Bracket (on
• Using a 4 mm hex wrench, tighten the first bolt firmly into the
bracket, so that the head of the bolt is inside the hole and will
prevent upward or downward tilt of the bracket.
Figure 124. Inserting the locking bolt on the
opposite side (-40° show).
• Repeat the previous two steps on the opposite side of the
speaker enclosure, making sure that the same corresponding
angle-selection hole aligns on both sides.
Advertisement
Table of Contents
