Table of Contents
Advertisement
CONTOUR CT28 WALL & CEILING INSTALLATION
Figure 18. Aligning the tilt arm and M6 bolts with the
M6 rigging points on the CT28
Important: For permanent or semi-permanent installation,
the use of medium-strength thread-locking compound is
recommended on all user-installed screws.
• Insert the two mounting ears of the tilt arm into the recesses
in the rear of the speaker enclosure, oriented so that the tilt
mechanism is towards the bottom (connector end) of the CT28.
• Align the four holes in the mounting ears of the tilt arm with the
M6 rigging points from which the screws have been removed.
• Thread the four M6 × 25 mm screws into the four rigging points
through the holes in the mounting ears of the tilt arm.
• Firmly tighten these four screws using a 4 mm hex driver.
Advertisement
Table of Contents
