Table of Contents
Advertisement
Chapter 3. Installing LCC44/LCC84
on a Wall Mount Bracket
Critical information
Attention: This wall-mount bracket is intended for installation by
qualified professionals.
Notice: Please read these instructions carefully and completely
before attempting installation.
Improper installation or suspension of any heavy load
can result in death or serious injury to persons, as well
as damage to property.
It is the responsibility of the installation personnel to
verify and guaranty the reliability and safety of the
installation.
Notice: This product must be installed in compliance with all
applicable local, state and national regulatory provisions. The
responsibility rests with the installer to verify that the installation
is carried out in accordance with any applicable legislation.
Important: The installer must assess the appropriate stability
and sturdiness of the mounting surface. In the case of wall-mount
and ceiling-mount brackets, this includes, but is not limited to
verifying the positions of suitable studs in the case of drywall
mounts, hollow points in concrete block or solid concrete, as well
as the presence and vicinity of electrical wiring or plumbing.
Restriction: Only hardware and accessories included with
the product or specified by 1 Sound should be used for its
installation.
Restriction: Do not modify or alter the loudspeaker or any
accessory. Any modification by the user or installer could render
the product or the installation unsafe.
Restriction: Do not install a loudspeaker or any accessory near
any open flame or heat source.
Products, accessories and tools required
To install an LCC44 or LCC84 enclosure permanently on a wall or surface
you will need the following:
•
An
LCC44 (on page 3)
enclosure
•
The corresponding
Bracket (on page 4)
•
An appropriate power drill and bit for the installation surface
material
•
A 5 mm hex (Allen) wrench
•
Medium-duty mounting screws or bolts appropriate to the
mounting surface (coach screws for drywall studs, concrete
screw anchors for concrete or masonry, etc.); screws and bolts
should have a flanged head or a coupled washer ø14-16 mm in
order to retain the mounting plate
•
Appropriate tools for securing the aforementioned fasteners
(power screwdriver etc.)
•
A Torque wrench
•
Optional: 4 mm hex (Allen) wrench, steel rope sling or chain, M6
lifting eye bolt (shouldered type); eye bolt spanner or driver
•
Recommended: pencil or marker, spirit level, stud finder
WARNING
or
LCC84 (on page 3)
LCC44 (on page 4)
or
LCC84 Wall Mount
kit
Procedures
Disassembling the bracket
The Wall Mount Bracket ships fully assembled, but to facilitate
installation, it should first be separated into two parts, the bracket itself
and the wall-mount plate. Before disassembly, be sure to note the proper
interlocking configuration of the tilt mechanism; this will remove doubts
when it is time to reassemble the bracket.
Figure 5. Loosening the tilt lock.
• Make sure that the tilt mechanism can move freely. If it does not,
use a 5 mm hex wrench to loosen slightly the horizontal hex-
head bolt near the top of the tilt/pan mechanism. The bracket
should be free to tilt, but this bolt should remain in place.
loudspeaker
Advertisement
Table of Contents
