Table of Contents
Advertisement
Figure 16. Removing the M6 mounting bolts from
the top of CT28.
• Using a 4 mm hex wrench or hex driver, remove the two M6
× 25 mm screws from the top rear of the enclosure, inside the
recess. Keep these, as they will be used to mount the bracket.
| 3 - INSTALLING CT28 ON THE WALL BRACKET
Figure 17. Removing the M6 bolts from the bottom
(connector end) of the CT28
• Repeat the previous step on the bottom (connector end) rear
of the enclosure.
Advertisement
Table of Contents
