Attaching A Safety Bridle - 1 Sound Contour CT28 Installation Manual

• Once the two primary bolts have been inserted to fix the tilt
angle, the secondary bolts should be inserted on each side
and threaded into the remaining inserts on the bracket. These
WILL NOT enter holes on the external plates of the bracket, but
will come into contact with the external surface of the plates,
between the holes.
Figure 82. Inserting the secondary bolts (-10° tilt
angle shown).
• When these two secondary bolts are threaded into the Bracket,
use a 4 mm hex wrench to tighten them securely. These two
secondary bolts serve to lock the two components of the bracket
together and prevent the external plate from slipping over the
head of the primary bolt, in case of unforeseen lateral or vertical
forces strong enough to flex or bend the bracket.
| 4 - INSTALLING CT28 ON THE HORIZONTAL MOUNTING BRACKET
Figure 83. Tightening the secondary bolts (-10° tilt
angle shown).
• It is now safe to release the speaker enclosure and verify the
stability and security of the installation.

Attaching a safety bridle

If the CT28 speaker enclosure has been equipped with swivel hoist rings
for a redundant safety bridle (steel wire rope), these must be attached to
the external anchor before concluding the installation.