Table of Contents
Advertisement
Figure 26. Removing the M5×25 mm countersunk
screws for the installation of safety anchors.
• Using a 3 mm hex wrench, remove the two rear M5×25 mm
countersunk screws from the top of the CT28 enclosure.
| 3 - INSTALLING CT28 ON THE WALL BRACKET
Figure 27. Inserting the M5 eye
bolts in the rigging points on the
top of the CT28 enclosure.
• Thread the M5 eye bolts into the rigging points from which the
screws were removed and tighten them with your fingers.
Figure 28. Tightening the eye bolts.
• Using a slotted socket or eye bolt spanner, firmly tighten the
eye bolts. Once seated, the eye bolts should be aligned with
the openings perpendicular to the orientation of the enclosure
(see illustration).
Installing the Wall Bracket to the wall
The mounting plate of the CT28 Wall Bracket must be firmly fitted to the
wall or surface before mounting and fixing the pan angle the speaker
enclosure.
Advertisement
Table of Contents
