Table of Contents
Advertisement
The Designer Series & P7 Industrial
2.3 middle panel
a) To attach hinge
P
to the top of the panel, align the
edges of the hinge with the vertical grooves in every
door stile, position the hinge as shown and affix with
2 tek screws (Fig 2.3.1a).
b) Before placing 2 end hinges
panel, remove the 2 axle plates
from each hinge (Fig 2.3.1b).
Apply general purpose grease to all axles
tip
before fitting them.
c) Slide in wheel axle
M
each end and put aside for later (Fig 2.4.1b).
d) The fixings must align with the vertical grooves in
the end stile then, measure down 15mm from the
top of the panel to mark the centre screw position
of each of the end hinges
alignment. Secure with eight (8) tek screws as
shown in Fig 2.4.1c.
Ensuring the hinges
tip
horizontally aligned across the panel
will provide a smoother door operation
(Fig 2.3.2d).
NOTE: Once the panel is in place the hinged
hangers
Q
can be adjusted if needed to ensure
the panels are parallel to the opening.
e) Repeat steps to assemble other middle panels.
installation instructions
™
Q
at either end of the
ii
, screws and nuts
onto the axle plates
ii
for
Q
to ensure horizontal
and
Q
are
P
M
ii
Q
Fig: 2.3.1b
Fig: 2.2.1c
Fig: 2.3.1
P
Fig: 2.3.2d
8
oil hole to
the top
P
Fig: 2.3.1a
Q
Q
Advertisement
Table of Contents
