Table of Contents
Advertisement
The Designer Series & P7 Industrial
3.5 install top panel
NOTE: Refer to appendix if installing a rear torsion systems as
installation of top panel may be different.
TWO PERSON LIFT: depending on the size of the
door, this process may require two persons to lift
into place.
a) Before adding the top panel fit a temporary spacer on
top of last panel, 1-2mm thick, at each panel joint to give
clearance between each panel in order to decrease
paint rub. Rest the top panel into position.
b) Thread the wheel axle
and slide the end hinges
(fig 3.5.1a standard, 3.5.1b for BTRK).
c) Secure end hinges, using installation tool with tek screws
as shown in both top corners of the panel and adjust
hinge to wheel height if necessary.
d) Attach top panel to panel below via the hinges on
previous panel.
Q
Fig: 3.5.1b
installation instructions
™
M
down the horizontal track
Q
onto the wheel axle
M
Q
M
Fig: 3.5.1a
Q
12
Q
Advertisement
Table of Contents
