Table of Contents
Advertisement
The Designer Series & P7 Industrial
3.3 adding panels
TWO PERSON LIFT: depending on the size of
the door, this process may require two persons
to lift into place.
a) Before adding the next panel into the tracks fit
a temporary spacer to the inside lip of the panel,
1-2mm thick, at each panel joint to give clearance
between each panel in order to decrease paint rub.
b) Carefully move the second panel into position
between the tracks as per Fig 3.3.1.
Apply general purpose grease to all axles
tip
before fitting them.
c) Slide in wheel axle
M
were removed in step 2.2f) and fit the wheel into
the vertical track, before lowering down onto end
hinges. (Fig 3.2.1) Secure axle plates with 4 screws
and nuts as shown, ensuring there is sufficient
clearance between the panel and the track as per
Fig 3.1.2.
d) Repeat step c) for other side of panel.
e) Screw the hangers and hinged hangers to the
lowered panel, before removing the temporary
spacer.
NOTE: The end hinges
Q
plate to ensure the panels are parallel to the opening.
f) Repeat steps a) - e) for all other panels with the
exception of the top panel which is positioned after
the horizontal track is installed.
g) Once satisfied with the door placement, secure all
fixing points on the vertical tracks.
CAUTION: Ensure the warning label is placed on
the door in a clearly visible position.
D O N O T R E M O V E , P A I N T O V E R O R C O N C E A L T H I S L A B E L
installation instructions
™
through 2 axle plates (that
are adjustable for the axle
WARNING
Components of this door are under extreme
spring tension and can cause serious injury if
When manually operating this door,
interfered with by an inexperienced person.
DO NOT place your fingers between the
Adjustment and repairs must be made by an
door panels.
experienced garage door technician, using
proper tools.
P/N MS0300
M
Q
Fig: 3.3.1
Fig: 3.3.2
10
Advertisement
Table of Contents
