Table of Contents
Advertisement
The Designer Series & P7 Industrial
5.3 hinged tapers
Tapers are accomplished using a small customised
panel, which results in a slight variation in the
installation process.
a) Assemble the bottom panel taking note that there
are no wheels or weather strip on the bottom panel,
these are both on the taper panel. Fig 5.4.1.
b) Connect the tapered panel to the bottom panel
using hinges provided.
tapered panel
assembly as
supplied
Fig: 5.4.1
Tracks are assembled as standard with the only
difference being that one vertical track needs to be
cut down to accommodate the uneven floor.
c) Start with both of the verticals tracks from the
ground and measure up to the level datum.
d) Cut the tracks as necessary from the ground end.
e) Follow the directions in section 3.1 to install tracks,
before proceeding to adding panels in section 3.2.
hinge used instead of
hanger at the sides
installation instructions
™
21
Advertisement
Table of Contents
