Table of Contents
Advertisement
The Designer Series & P7 Industrial
6.0 after installation care
general care of your Designer Series
cleaning
Your B&D Designer Series/P7 Industrial
from aluminium extrusions and are hence resistant to
corrosion, however in our atmosphere there are harmful
deposits that gather on the door surface and if not
removed regularly, will seriously affect the appearance.
Touch up paint is available for blemishes in the paintwork
where damage has been done in powder coated doors.
hinges
If the hinges and hangers squeak and squeal during
operation then the hinges haven't been greased or the
grease has dried up. Please apply some grease into the
holes in the hangers and hinges as pointed out in the
diagram below.
b&d doors office locations
Head Office
6-8 Fiveways Blvd, Keysborough 3073
New South Wales
34 Marigold St, Revesby 2212
Queensland
17 Oasis Court, Clontarf 4019
Victoria
147-153 Canterbury Rd, Kilsyth 3137
South Australia
23 Frederick Rd, Royal Park 5014
Western Australia
96 Mulgul Rd, Malaga 6090
International/Export
34 Marigold St, Revesby 2212
Prefixed trademarks are the property of B&D Australia Pty Ltd. B&D Doors & Openers
is a division of B&D Australia Pty Ltd. ABN 25 010 473 971. © 2018 B&D Australia Pty Ltd.
www.bnd.com.au
installation instructions
™
™
panels are made
hinge grease holes
Phone (03) 9791 2000
Phone (02) 9722 5555
Phone (07) 3883 0200
Phone (03) 9237 7766
Phone (08) 8440 4747
Phone (08) 9247 8777
Phone +61 (0)2 9722 5555
regular maintenance required
B&D recommends that you check the operation of your
Designer Series/P7 Industrial
(more regularly in extreme environments or frequent use).
The effort required to manually open and to manually
close the door should be about the same (if door has an
automatic opener, put into manual mode before testing
door). If the door is difficult to operate in either direction
(up or down) then check that the inside surfaces of the
guides are clean and free of obstructions.
If the door is still difficult to operate, then your door will
need a service to adjust the spring tension and possibly
other operational parts of the door. This service should
only be carried out by an experienced door technician,
using the correct tools.
If you have an automatic opener fitted to your door, it
is particularly important that you ensure the optimum
operation of the door, otherwise you may reduce the
effective life of the opener.
To keep your door running well, it is recommended
that your door be serviced, by an experienced door
technician, every 12 months (more regularly in extreme
environments or frequent use), or earlier if required.
spring tension
It is natural for springs to lose tension over time. When
spring tension is adjusted or when your door is first
installed it is usual to apply a little more tension than is
required for balanced operation, to allow for the normal
"settling in" of the springs.Lightly lubricate to prevent
friction between the coils.
warranty
Warranty conditional on proper care as recommended
above. Full details of the warranty are available in your
owners handbook, from your nearest B&D office or visit
the B&D website www.bnd.com.au
your representative is
22
™
at least every six months
Advertisement
Table of Contents
