Advertisement
Auto-Lock Kit - Installation instructions
prior to installation
Preparation - setting the door limits
Ensure the door limits have been set on the opener,
prior to installing the Auto-lock. Refer to the opener
manual for instructions.
install batteries
a. Insert batteries
into drive unit.
4
b. Place cover back on drive unit
and secure with 4 x screws
standard installation
preparation - no brackets, mounting on track
a. With the door closed, mark the
position of the top of the second
door wheel on the inside of the
track.
b. Place the drilling template
label with the Datum line on top
of the line marked inside.
3
.
3
(side mount)
2
c. Using an 6mm and 18mm
stepped drill, drill marked holes
through the guide and remove
any burs from holes.
d. Assemble the Autolock
6
track using 2 x screws
WARNING!
remove
systems prior to installing lock. Any damage
as a result of a manual lock will void the
warranty for the door, Auto-lock and opener.
program lock
a. Press and hold the info button
unit until the light goes red.
b. Then press the lock/unlock button to test
4
the drive unit.
1
e. Close the door and check the
position of the lock to the wheel,
there should be a 10mm clearance.
f. Test the operation of the AutoLock
to the
by
1
,
button to ensure the lock bolt fully
2
engages through the guide without
interference.
PROCEED TO CONNECTING
BASE STATION TO THE OPENER.
2
all
manual
locking
on drive
i
lock bolt flush
with inside of
guide
lock bolt when
engaged with
10mm clearance
pressing
the
lock/unlock
Advertisement
