Cleaning Lex Device; Cleaning Interface Connector; Cleaning Battery Contacts - Motorola LEX L10i User Manual

• Isopropyl alcohol
• Can of compressed air with a tube
Cleaning Frequency
The cleaning frequency is up to your discretion due to the varied environments in which the mobile
devices are used. They may be cleaned as frequently as required, but it is advisable to clean the
camera window periodically when used in dirty environments to ensure optimum performance.
13.4

Cleaning LEX Device

This section includes instructions on how the LEX device should be cleaned.
Housing
Using the alcohol wipes, wipe the housing including buttons.
Display
The display can be wiped down with the alcohol wipes, but care should be taken not to allow any
pooling of liquid around the edges of the display. Immediately dry the display with a soft, non-abrasive
cloth to prevent streaking.
Camera Window
Wipe the camera window periodically with a lens tissue or other material suitable for cleaning optical
material such as eyeglasses.
13.5

Cleaning Interface Connector

When and where to use: Use this procedure to clean the contacts of the interface connector on LEX
device.
Procedure:
1 Power off the device.
2 Dip the cotton portion of the cotton-tipped applicator in isopropyl alcohol.
3 Rub the cotton portion of the cotton-tipped applicator along the contacts of the interface
connector. Slowly move the applicator back-and-forth from one side of the connector to the
other.
4 If grease and other dirt can be found on other areas of the cradle, remove using a lint-free cloth
and alcohol.
5 Allow few minutes (depending on ambient temperature and humidity) for the alcohol to air dry
before powering on the device.
13.6

Cleaning Battery Contacts

When and where to use: Perform this procedure to clean the battery connectors.
Procedure:
1 Remove the main battery from device.
Send Feedback
Chapter 13: Maintenance and Troubleshooting
MN003475A01-B
163