Call Settings - Motorola LEX L10i User Manual

5.6

Call Settings

Use Call Settings to modify options related to the phone call feature.
NOTICE: Not all options are available for all configurations.
• Sounds and Vibration
- Phone Ringtone — Tap to select a ringtone to sound when an incoming call is received.
- Also vibrate for calls — Check to make the device vibrate when a call is received.
- Dialpad tones — When enabled, pressing the numbers on the dial pad within the Dialer / Phone
app plays tones.
• Display options
- Sort by
- Name format
• Quick Responses — Tap to edit quick responses to use instead of answering a call.
• Calls
- Calling Accounts — Tap to configure account settings.
+ Use Internet calling — Set internet calling options.
+ Receive Incoming Calls — Set to enable/disable incoming calls.
+ Display Duration — Set display duration ON.
+ Vibrating After Connected — Enable vibration when answering calls.
- Voicemail — Tap to configure voicemail settings:
+ Service — Set the service provider or other provider for voicemail service.
+ Setup — Tap to update the phone number used to access voicemail.
+ Sound — Tap to select a sound when a voicemail is received.
+ Vibrate — Tap to vibrate when a voicemail is received.
- Fixed Dialing Numbers — Use Fixed Dialing to restrict the phone to dial only the phone
number(s) or area code(s) specified in a Fixed Dialing list.
- Turn on Video Calling - Enable video calling.
• Accessibility
- TTY mode — Tap to set the TTY setting. Use an optional teletypewriter (TTY) device with the
LEX device to send and receive calls. Plug the TTY device into the device headset jack and set
the device to operate in one of the TTY modes.
NOTICE:
Use a TSB-121 compliant cable (provided by the TTY manufacturer) to connect the TTY
device to the LEX device.
Set the device volume to a middle level setting for proper operation. If you experience a
high number of incorrect characters, adjust the volume as needed to minimize the error
rate.
For optimal performance, the device should be at least 30 cm (12 inches) from the TTY
device. Placing the device too close to the TTY device may cause high error rates.
+ TTY Off (default) — TTY is off.
+ TTY Full — Transmit and receive TTY characters.
Send Feedback
MN003475A01-B
Chapter 5: Calling
87