Table of Contents
Advertisement
16
Installing the Mounting Plate in the Monitor Carriage
Fig. 5:
Mounting plate in the monitor carriage
Pos. 1
Guide bracket, side
Pos. 2
Guide brackets, rear
•
Insert the mounting plate completely into the top compartment of the monitor carriage
from behind.
•
Install the mounting bracket
plate, but do not tighten it yet.
•
Hold the mounting bracket vertically and thread in the 2nd screw with washer, but do
not tighten it yet.
•
Slide the mounting bracket up to the stop and tighten it in place.
Wiring the Network Cable
•
Plug in the network cable that is provided to the RJ45 socket on the WLAN Client.
•
Lay the network cable from the WLAN Client to the existing network switch (network
hub).
•
Plug in the network cable at one of the free RJ45 sockets on the network switch.
ARCADIS
The side guide bracket
The rear guide brackets
riage.
The mounting plate can no longer be lifted out of the rear guide brackets.
DRAFT 22.04.2008
SP00-000.814.09.01.02
11.07
Installing the WLAN Expansion
Fig. 6:
Pos. 1
(1/Fig. 5 / p. 16)
is on the vertical ledge.
(2/Fig. 5 / p. 16)
are on the rear ledge of the monitor car-
(1/Fig. 6 / p. 16)
with a screw and washer on the mounting
Page 16 of 78
CS PS SP
Installing the mounting bracket
Securing the mounting bracket with mounting
plate
0
0
Siemens
Medical Solutions
Advertisement
Table of Contents
