20
Installation with the Monitor Carriage, 10143404
Overview of Required Parts
Fig. 11: WLAN electronics, cables and labels
Pos. 1
Pos. 2
Pos. 3
Pos. 4
Pos. 5
Pos. 6
Pos. 7
Pos. 8
Pos. 9
Removing the Cover Panels
•
Remove the large, rear cover panel on the monitor carriage.
•
Remove the small cover panel on the right (network connection panel) on the monitor
carriage.
•
Remove the cover panels on the right and left sides on the monitor carriage.
ARCADIS
NOTE
Perform this section only if the monitor carriage, 10143404,
is configured.
NOTE
As a prerequisite for installation, the 2-part network connec-
tion, 10143416, must already be installed.
If this is not the case, install the 2-part network connection
according to these installation instructions prior to install-
ing the WLAN Expansion.
WLAN Client
WLAN Client antenna sockets
WLAN Client antennas
WLAN power supply
WLAN Client RJ45 cable - network switch
WLAN power switch cable, power outlet strip
WLAN power switch cable - WLAN power supply
24V WLAN Client cable - WLAN power supply
Label with reference to the Operator Manual
DRAFT 22.04.2008
SP00-000.814.09.01.02
11.07
Installing the WLAN Expansion
Parts not shown:
Page 20 of 78
CS PS SP
WLAN power switch
End pieces for the cap rail
Medical Solutions
2.1
0
0
Siemens