Pulse Generator 設定一覧 - IAI GO-5000M-PGE User Manual

6.5.11 Pulse Generator 設定一覧
表 14 Pulse Generator 設定一覧
Display Name
Clock Pre-scaler
Pulse Generator Clock (MHz)
Pulse Generator Selector
- Pulse Generator Length
- Pulse Generator Length (ms)
- Pulse Generator Frequency (Hz)
- Pulse Generator Start Point
- Pulse Generator Start Point (ms)
- Pulse Generator End Point
- Pulse Generator End Point (ms)
- Pulse Generator pulse-width (ms)
- Pulse Generator Repeat Count
- Pulse Generator Clear Activation
Clear Mode for the Pulse Generators
- Pulse Generator Clear Sync Mode
- Pulse Generator Clear Source
- Pulse Generator Inverter(Polarity)
Pulse Generator Clear Inverter
[注記] (1) Pulse Generator Repeat Count = "0" と設定した時、Free Running となります。
(2) 同一 Pulse Generator の出力を Clear 入力に接続できない様に設定制限があります。
GO-5000M-PGE / GO-5000C-PGE
Vale
1 to 4096
[Pixel Clock:48MHz]÷[Clock Per-scaler]
- Pulse Generator 0
1 to 1048575
（[Clock Source]÷[Clock Per-scaler]）
［ Pulse Generator Length (ms)］
0 to 1048574
（[Clock Source]÷[Clock Per-scaler]）
1 to 1048575
（[Clock Source]÷[Clock Per-scaler]）
[ Pulse Generator End Point (ms)]－[ Pulse Generator Start Point (ms)]
0 to 255
- Off
- High Level
- Low level
- Rising Edge
- Falling Edge
- Async mode
- Sync mode
- Low
- High
- Frame Trigger Wait
- Frame Active
- Exposure Active
- FVAL
- LVAL
- PulseGenerator0
- Opt 1 In
- User Output 0
- User Output 1
- Action 1
- Action 2
- Nand0 Out
- Nand1 Out
- False
- True
- 24 -
-1
x [Pulse Generator Length]
-1
-1
x [Pulse Generator Start Point]
-1
x [Pulse Generator End Point]