Table of Contents
Advertisement
1
DO NOT ENTER GRAIN TANK WHEN
AUGER IS RUNNING.
2
8
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!
Replace Immediately If Damaged or Missing
3
4
KEEP OFF THE LADDER WHILE
THE MACHINE IS OPERATING,
IN TRANSPORT OR THE
UNLOADING AUGER IS IN MOTION
KEEP OFF THE LADDER WHILE
DO NOT ENTER GRAIN TANK WHEN
THE MACHINE IS OPERATING,
AUGER IS RUNNING.
IN TRANSPORT OR THE
UNLOADING AUGER IS IN MOTION
Description
1
J&M Oval Decal (Large) 9-1/2" x 15"
2
www.jm-inc.com Decal
3
Danger, Do Not Enter Grain Tank Decal
4
Danger, Keep Off Ladder Decal
5
Warning, Keep Hands Away Decal
6
Closed Decal
7
Open Decal
8
Danger, Electric Lines Decal
9
J&M Oval Decal (Medium) 5-1/2" x 8-1/2"
10 Danger, Keep Hands and Clothing Away Decal
11 California Proposition 65 Warning Decal
12 Danger Warning Important Decal
13 Lock and Load Indicator Lights Decal
Decals
8
5
6
7
WARNING
12 Volt
Active
NEVER PLAY IN OR
YOU CAN DIE IN
•
Do not adjust, service, clear, or lubricate the machine until all
OPERATING INSTRUCTIONS
CALIFORNIA PROPOSITION 65 WARNING
ON GRAIN CART
SECONDS IN
power is shut off.
With the gate indicator in the closed position, fill the box with
•
Lock-n-Load
FLOWING GRAIN!
•
•
Keep all safety shields in place.
Keep people and objects clear of equipment before applying
grain.
THIS PRODUCT MAY CONTAIN A CHEMICAL
Active
power or moving machine.
•
With the PTO disengaged, fold discharge auger to upright
KNOWN TO THE STATE OF CALIFORNIA TO CAUSE
Close Gate To Fold Auger
•
Before highway travel, secure a slow-moving vehicle emblem to
position.
CANCER, BIRTH DEFECTS, OR OTHER
laws.
the rear of the machine in accordance to the state and local
After auger is in the upright position, start the PTO at a SLOW
RATE OF SPEED until the pin on the upper auger engages the
•
REPRODUCTIVE HARM.
•
Make sure all flashers and turn/brake lights are working properly
drive dog on the bottom auger(failure to follow this procedure
BEFORE incidental highway travel.
may cause extensive damage to both the drive dog and the pin).
For more information: www.p65warnings.ca.gov
CHECK TIRE INFLATION
Increase PTO speed to 1000 RPM and open inner gate until the
•
FLOWING GRAIN TRAPS AND SUFFOCATES VICTIM IN SECONDS!
Do not inflate tires more than 6 PSI over the recommended
from the discharge auger, open gate to the full position.
pointer is in the halfway position. When grain begins flowing
pressure printed on the side of the tire.
Once the grain has ceased to flow, return the gate to the closed
•
CHECK ALL WHEEL NUTS
position (for complete clean-out, gradually close gate, allowing
SERIOUS INJURY OR
Dealer or manufacturer is not responsible for damaged caused by
the opening to be reduced). Disengage the PTO and allow its
DEATH CAN RESULT WITH
loose wheel nuts.
returned to the lowered position.
rotation to come to a complete stop. Auger is now ready to be
ELECTRIC LINES.
HIGH-PRESSURE FLUID HAZARD
Do not operate or service machine until you
OR OPERATING MACHINE
USE CARE WHEN MOVING
To prevent serious injury or death:
read and understand operator's manual.
NEAR ELECTRIC LINES TO
• Relieve pressure on system before
AVOID CONTACT.
• Wear proper hand and eye protection
repairing, adjusting or disconnecting.
when searching for leaks.
• Keep all components in good repair.
JM0037665
13
12 Volt
Active
Lock-n-Load
Active
Close Gate To Fold Auger
9
10
KEEP HANDS AND CLOTHING AWAY
FROM MOVING PARTS
WARNING
11
CALIFORNIA PROPOSITION 65 WARNING
THIS PRODUCT MAY CONTAIN A CHEMICAL
KNOWN TO THE STATE OF CALIFORNIA TO CAUSE
CANCER, BIRTH DEFECTS, OR OTHER
REPRODUCTIVE HARM.
For more information: www.p65warnings.ca.gov
12
NEVER PLAY IN OR
YOU CAN DIE IN
Do not adjust, service, clear, or lubricate the machine until all
OPERATING INSTRUCTIONS
•
ON GRAIN CART
SECONDS IN
power is shut off.
•
With the gate indicator in the closed position, fill the box with
FLOWING GRAIN!
•
Keep all safety shields in place.
grain.
•
Keep people and objects clear of equipment before applying
•
With the PTO disengaged, fold discharge auger to upright
power or moving machine.
•
Before highway travel, secure a slow-moving vehicle emblem to
position.
the rear of the machine in accordance to the state and local
•
After auger is in the upright position, start the PTO at a SLOW
laws.
RATE OF SPEED until the pin on the upper auger engages the
•
Make sure all flashers and turn/brake lights are working properly
drive dog on the bottom auger(failure to follow this procedure
BEFORE incidental highway travel.
may cause extensive damage to both the drive dog and the pin).
•
Increase PTO speed to 1000 RPM and open inner gate until the
CHECK TIRE INFLATION
pointer is in the halfway position. When grain begins flowing
FLOWING GRAIN TRAPS AND SUFFOCATES VICTIM IN SECONDS!
Do not inflate tires more than 6 PSI over the recommended
from the discharge auger, open gate to the full position.
pressure printed on the side of the tire.
•
Once the grain has ceased to flow, return the gate to the closed
CHECK ALL WHEEL NUTS
position (for complete clean-out, gradually close gate, allowing
the opening to be reduced). Disengage the PTO and allow its
SERIOUS INJURY OR
Dealer or manufacturer is not responsible for damaged caused by
loose wheel nuts.
rotation to come to a complete stop. Auger is now ready to be
DEATH CAN RESULT WITH
returned to the lowered position.
ELECTRIC LINES.
HIGH-PRESSURE FLUID HAZARD
Do not operate or service machine until you
USE CARE WHEN MOVING
To prevent serious injury or death:
read and understand operator's manual.
OR OPERATING MACHINE
• Relieve pressure on system before
NEAR ELECTRIC LINES TO
repairing, adjusting or disconnecting.
AVOID CONTACT.
• Wear proper hand and eye protection
when searching for leaks.
• Keep all components in good repair.
Part No.
JM0015151
JM0019239
JM0018033
JM0018034
JM0018039
JM0025434
JM0025433
JM0015099
JM0010179
JM0018035
JM0077568
JM0037665
JM0044289
JM0037665
Advertisement
Table of Contents
