VTech SIP Contemporary Series User Manual page 3

15. Avoid using a telephone (other than cordless)
during an electrical storm. There is a remote
risk of electric shock from lightning.
16. Do not use the telephone to report a gas
leak in the vicinity of the leak. Under certain
circumstances, a spark may be created
when the adapter is plugged into the power
outlet, or when the handset is replaced in its
cradle. This is a common event associated
with the closing of any electrical circuit. The
user should not plug the phone into a power
outlet, and should not put a charged handset
into the cradle, if the phone is located in
an environment containing concentrations
of flammable or flame-supporting gases,
unless there is adequate ventilation. A spark
in such an environment could create a fire or
explosion. Such environments might include:
medical use of oxygen without adequate
ventilation; industrial
solvents; petrol vapours; etc.); a leak of
natural gas; etc.
17. Only put the handset of your telephone next
to your ear when it is in normal talk mode.
18. The power adapters are intended to be
correctly oriented in a vertical or floor mount
position. The prongs are not designed to
hold the plug in place if it is plugged into a
ceiling, under-the-table or cabinet outlet.
19. Use only the power cord and batteries
indicated in this manual. Do not dispose of
batteries in a fire. They may explode. Check
with local codes for possible special disposal
instructions.
20. In wall mounting position, make sure to
mount the telephone base on the wall by
aligning the eyelets with the mounting studs
of the wall plate. Then slide the telephone
base down on both mounting studs until it
locks into place. Refer to the full instructions
in Installation in the user's manual.
21. This product should be mounted at a height
of less than 2 meters.
gases (cleaning
EN - 3
22. Listed PoE (The product is considered not
likely to require connection to an Ethernet
network with outside plant routing).
CAUTIONS
• Keep small metallic objects such as pins and
staples away from the handset receiver;
• For pluggable equipment, the socket-outlet
shall be installed near the equipment and
shall be easily accessible;
• The applied nameplate is located at the
bottom of the product;
• The equipment is only used for mounting
at heights < 2m.
SAVE THESE INSTRUCTIONS