VTech SIP Contemporary Series User Manual page 10

Installation option - converting from desktop to wall mount position
To mount the telephone base on the wall
1. Put the corded handset aside. On the telephone base cradle, place a coin in the slit of the wall
mount clip and rotate a half turn (180 degrees). It locks into place with the protruding edge
pointing towards the upper edge of the telephone base. This protruding edge holds the corded
handset when the phone is mounted on the wall.
2. Unplug the telephone line cord from the telephone wall jack. Then press the large tab on the
mounting bracket to remove it from the upper groove on the telephone base.
3. Turn the mounting bracket upside down. Remove the telephone line cord from the wire duct and
then route it through the groove on the bottom part of the mounting bracket. Insert the small tabs
on the mounting bracket into the upper slots on the telephone base. Then press the large tab on
the mounting bracket and firmly push it into the lower groove on the telephone base.
EN - 10
Protruding edge