VTech SIP Contemporary Series User Manual page 9

Telephone base installation
3. Install the telephone base as shown below. Then connect the coiled handset cord to the telephone
base.
Cat-5 network cable
Once installed, the telephone begins a four-step initialization and system registration process.
MUTE /
(1) The
MUTE /
(2) The
(3) The MUTE /
(4) The MESSAGE WAITING LED,
initialization and system registration are successful.
If the system registration fails,
To reset, disconnect the Cat-5 network cable from the network wall jack with Power over Ethernet
(PoE) and then reconnect.
CAUTIONS
Use only the supplied network cable.
The supplied network cable is not designed for use in any other IT devices. Misusing it on your other
IT devices shall be prohibited.
To order a replacement, call +44 (0)1706 694 070 or email ukca@trustdistribution.com.
SPEAKER key
key and the
key flashes.
key stops flashing.
MUTE /
SPEAKER key
the
Network wall jack with Power over
Ethernet (PoE)
turn on and then go off.
and the SPEAKER key
flashes twice every second.
EN - 9
illuminate for 500ms when