Programming; Programming Pads (1-8) - Amana Menumaster JetWave lll Owner's Manual

Programming

ENUMASTER
J
ETWAVE III
Programming Pads ( 1–8 )
Pads ( 1–8 ) activate a programmed cooking
sequence when pressed. Program each pad
individually to form menus. Programming remains
in memory until reprogrammed.
Programming Mode
1. Verify oven shows "READY" in display.
• If oven display shows "STANDBY",
press ON/STANDBY pad.
• If "R" in "READY" is not flashing, open
and close oven door.
• Preheat temperature and "PREHEAT"
appear in display if oven is in preheat
mode.
2. Open oven door. Oven door must remain
open during programming.
3. Press and hold 1 pad for approximately 3-5
seconds.
SELECT MENU AND PAD
A PAD ?
Current Menu
4. Press MENU A B C pad, if necessary, to
select menu.
5. Press desired ( 1–8 ) pad.
SELECT COOK FUNCTION
STAGE 1
A PAD 1
Current Menu
6. Press MICROWAVE , CONVECTION , or
COMBINATION pad to select cooking
function.
7. Set time, temperature, and/or power levels.
• If MICROWAVE pad is chosen, see
"Manual Microwave Entry" steps 3–6.
• If CONVECTION pad is chosen, see
"Manual Convection Entry" steps 4–7.
• If COMBINATION pad is chosen, see
"Manual Combination Entry" steps 4–9.
HIDDEN
ON
PRE-
ENABLE
STANDBY
HEAT
PAD
8. Press OPTION pad after setting time,
temperature, and/or power levels to
advance to next stage.
• Repeat steps 4–6 up to 4 times to
9. Press START pad to save cooking
sequences. Oven display shows "SELECT
MENU AND PAD" and
"(A, B, or C) PAD ?".
• Repeat steps 4-8 to program additional
10. Close oven door to exit programming
mode.
Summary of Programming Preset Pads
1. Open oven door.
2. Press and hold " 1 " pad.
3. Press MENU A B C pad to select menu.
4. Press ( 1–8 ) pad to be programmed.
5. Press MICROWAVE , CONVECTION , or
6. Set time, temperature, and microwave power level
7. Press OPTION pad to set second stage or START pad
8. Close oven door.
MICROWAVE CONVECTION COMBINATION
MENU
A B C
create a maximum of 4 cooking stages.
If no additional cooking stages are
required, go to next step.
SELECT COOK FUNCTION
A PAD 1 STAGE 2
Current Menu
pads
COMBINATION pad.
according to instructions.
to save entry. Repeat 4-8 to program additional pads.
16
OPTION
START
1
2
3
4
5
6
7
8
STOP
RESET