Manual Combination Entry - Amana Menumaster JetWave lll Owner's Manual

ON
MENU
PRE-
STANDBY
A B C
HEAT

Manual Combination Entry

Combination function cooks using a
combination of convection heat and microwave
energy. Preheat oven before using combination
function for best results. Set time, temperature,
and microwave power level.
To prevent personal injury, handle
utensils, racks, and door with
care. Utensils, racks, and door
may become hot during operation.
Operating Combination Function
1. Set preheat mode. See "Preheat Entry"
section to set preheat mode.
2. Verify oven shows "READY" in display.
• If oven display shows "STANDBY",
press ON/STANDBY pad.
• If "R" in "READY" is not flashing, open
and close oven door.
• Preheat temperature and "PREHEAT"
appear in display if oven is in preheat
mode.
475F PREHEAT
MENU A READY
Status
Current Menu
3. Press COMBINATION pad to select
combination function. Colon (:) in cooking
time flashes.
Cooking Time Microwave Power Level
2:00 475F MICRO HI
MANUAL STAGE 1 c
Cooking Temperature Current Stage
4. Press arrow keys to add or subtract
cooking time.
5. Press OPTION pad. "F" flashes after
temperature.
6. Press arrow pads to increase or decrease
oven temperature. Cooking temperature
should equal preheat temperature for best
results.
7. Press OPTION pad.
MICROWAVE CONVECTION COMBINATION
Caution
c
OPTION
8. Press arrow pads to increase or
decrease microwave power level. For
example, press the down arrow once for
"90%".
• If no additional cooking stages are
required go to step 8.
9. Press OPTION pad. Oven display shows
"PROGRAMMING STAGE (2–4)" for 2
seconds, and then display shown below.
• Repeat steps 3–7 if additional cooking
stages are required. See Oven
Operation section under Cooking for
explanation of stages.
SELECT COOK FUNCTION
MANUAL STAGE 2
10. Open oven door, place food in oven, and
close door.
11. Press START pad. Total time for each
stage selected counts down. Oven stops
and signals at end of cooking sequence.
12. Remove food to avoid overcooking.
Pause or Cancel
1. Press STOP/RESET pad or open oven
door to pause cooking sequence.
2. Press STOP/RESET pad again to
cancel cooking program.
Summary of Combination Entry
1. Preheat oven.
2. Verify oven display shows "READY".
3. Press COMBINATION pad.
4. Press arrow pads to add or subtract cooking time.
5. Press OPTION pad.
6. Press arrow pads to increase or decrease cooking
temperature.
7. Press OPTION pad.
8. Press arrow pads to increase or decrease microwave
power level.
9. Press OPTION pad. Repeat steps 3–7 for additional
stages.
10. Open oven door, place food in oven, and close door.
11. Press START pad.
12. Remove food.
15
START
1
2
3
4
5
6
7
8
STOP
RESET