Programming User Options - Amana Menumaster JetWave lll Owner's Manual

ENUMASTER
J
ETWAVE III

Programming User Options

User options change oven features to meet
specific needs. See table on next page for
options.
Setting User Options
1. Verify oven shows "READY" in display.
• If oven display shows "STANDBY",
press ON/STANDBY pad.
• If "R" in "READY" is not flashing, open
and close oven door.
• Preheat temperature and "PREHEAT"
appear in display if oven is in preheat
mode.
2. Open oven door. Oven door must remain
open during programming.
3. Press and hold 1 pad for approximately
3–5 seconds.
SELECT MENU AND PAD
A PAD ?
Current Menu
4. Press hidden enable pad located left of ON/
STANDBY pad.
USER OPTIONS: PRESS
DIGIT PADS TO REVIEW
5. Press ( 1–8 ) pads to review options. See
table on next page for descriptions.
6. Press arrow pads to select option.
7. Press START pad to enter option.
8. Close door to exit user options programming
mode.
HIDDEN
ON
PRE-
ENABLE
STANDBY
HEAT
PAD
Summary of Setting User Options
1. Open oven door.
2. Press and hold 1 pad.
3. Press hidden enable pad.
4. Press ( 1–8 ) pads.
5. Press arrow pads.
6. Press START pad to save.
7. Close door to exit.
MICROWAVE CONVECTION COMBINATION
MENU
A B C
17
OPTION
START
1
2
3
4
5
6
7
8
STOP
RESET