Assembling The Cultivator; Installing The Drag Stake; Installing The Support Wheel; Assembling The Handle - Fieldmann FZK 6115 B Manual

EN 8

Assembling the cultivator

5. ASSEMBLING THE CULTIVATOR
IMPORTANT INFORMATION: Carefully unfold the cultivator handle, being careful not to pinch or
damage the cultivator's control cables.
Caution! Assemble the cultivator on a level surface.

INSTALLING THE DRAG STAKE

1. Slide the drag stake (Fig. 2, point 1) through the prepared opening at the rear of the cultivator and secure it in
at the required height using a cotter pin (Fig.2, point 2).

INSTALLING THE SUPPORT WHEEL

1. Place the wheel (Fig. 3, point 1) into the prepared opening at the bottom of the cultivator and secure it in place
using the included bolt (Fig. 3, point 2).
2. Slide the spring on to the wheel axle and secure in place using the cotter pin (Fig. 3, point 3).

ASSEMBLING THE HANDLE

1. First attach the handles in the middle part Fig. 4. The engine speed adjustment lever must be located on the
right side. The handle with the cultivating blade control lever must be on the left side.
2. Attach both handles on each side using two bolts - Fig. 5. A washer must be placed underneath the head of
the screw.
Fig. 4
Fig. 2 Fig. 3
Fig. 5